Have your contractor do a load calculation based on a recognized method, such as one in Manual J from the ACCA. The contractor’s evaluation should include whether your ducts need to be resized, sealed and insulated, or replaced. Remember that an indoor evaporator coil and outdoor condenser must be a matched set from the same brand, or the performance, efficiency, and capacity might not meet expectations.

Some systems include an "economizer mode", which is sometimes called a "free-cooling mode". When economizing, the control system will open (fully or partially) the outside air damper and close (fully or partially) the return air damper. This will cause fresh, outside air to be supplied to the system. When the outside air is cooler than the demanded cool air, this will allow the demand to be met without using the mechanical supply of cooling (typically chilled water or a direct expansion "DX" unit), thus saving energy. The control system can compare the temperature of the outside air vs. return air, or it can compare the enthalpy of the air, as is frequently done in climates where humidity is more of an issue. In both cases, the outside air must be less energetic than the return air for the system to enter the economizer mode.
Inside the unit, the air passes over the evaporator coil first, and is cooled and dehumidified. The now dehumidified, cold air then passes over the condenser coil where it is warmed up again. Then the air is released back into the room. The unit produces warm, dehumidified air and can usually be placed freely in the environment (room) that is to be conditioned.

Contact/Relay -- Relays are electronically controlled switches that activate the various components of your HVAC system. They manage everything from the power going to the motor to automatic dampers, humidifiers, etc. Most of them are controlled by the thermostat. The most common failure for a relay is being stuck in the "open" position. Separated from its assigned contact point, it fails to complete the connection and send the message to whatever it was supposed to operate. This failure usually occurs from use over time. Each time a relay connects and sends its signal, the electrical arcing from point to point eventually causes wear and tear.
We maintain a complaint-free A+ rating with the Better Business Bureau, and are a 2017 Better Business Award Winner for ethics. Comfort Plus Services has achieved recognition as a Carrier Factory Authorized Dealer for sound business practices, technical expertise, and customer approval ratings. We simplify the demands of local weather and a comfortable home with upfront pricing, honest estimates, comprehensive service plans, and Emergency Service throughout Salisbury, Fruitland, Delmar, Hebron, Eden, Delmar, Parsonsburg, Pittsville, Mardela Springs, Princess Anne & Willards, MD and more. See our Areas of Service. For new home comfort systems, Comfort Plus Services protects your interests with a 100% money back guarantee. We provide expert service you can trust.
You might guess it from the name: the heat exchanger is the part of your furnace that actually heats the air your blower motor pushes through the furnace. It consists of a chamber in which the heat energy produced by natural or propane gas is transferred to the forced air. At the same time, this part also includes a vent through which the gases themselves are safely removed from the unit and the air that enters your home. Because of these gases, a problem with your heat exchanger needs to be dealt with promptly. Over time, cracks in the exchanger can result in carbon monoxide leaks. Taking care of the problem once again means understanding the existence of a range: repairing your heat exchanger can cost as little as $100, but a full replacement may cost up to $1,200.
Since first opening our doors in 1984, BJ Heating & Cooling continues to serve our communities in Kentuckiana with trustworthy, affordable, and state-of-the-art solutions to indoor temperature control. It is our goal to improve your everyday life through superior comfort, convenience, and control over your indoor environment. Our staff is fully licensed, insured, and specialized in the most advanced techniques, technology, and products on the market. We custom design/build heating, cooling and air quality systems to answer your exact requirements and achieve your highest expectations.
Summers in Portland and The Dalles can be the absolute best time of year or pure torture.  Your cooling system makes the difference. Take advantage of perfectly maintained temperatures, superior dehumidification, unprecedented energy efficiency, and outstanding reliability with quality air conditioning products and services from Sky Heating & Air Conditioning.  We protect the enjoyment of your home with precise installation, system replacement, seasonal maintenance, and prompt repair.  Our skilled AC technicians are always on call 24 hours a day, 7 days a week, providing Emergency Service and protecting the value of your investment.  Every project is answered with a dedication to customer satisfaction that has earned us an A+ rating from the Better Business Bureau. Contact Sky Heating & Air Conditioning for air conditioning service in The Dalles and Portland, OR.  
Cleaning the debris that builds up on your filters will aid with the flow of air. When your air filter is clogged, your air handler must work harder to compensate for the blockage of air flow. In addition to driving up your utility bill, the reduced air flow through your heating and cooling system can cause your heat exchanger to overheat and shut off too quickly.    
The manufacture and use of CFCs has been banned or severely restricted due to concerns about ozone depletion (see also Montreal Protocol).[63][64] In light of these environmental concerns, beginning on November 14, 1994, the U.S. Environmental Protection Agency has restricted the sale, possession and use of refrigerant to only licensed technicians, per rules under sections 608 and 609 of the Clean Air Act.[65]
Demand controlled kitchen ventilation (DCKV) is a building controls approach of slowing down kitchen exhaust fans and subsequent supply air in response to the actual cooking loads in a commercial kitchen. Traditional commercial kitchen ventilation systems operate at 100% fan speed independent of the volume of cooking activity and DCKV technology changes that to provide significant fan energy and conditioned air savings. By deploying smart sensing technology, both the exhaust and supply fans can be controlled to capitalize on the Law of Affinity for motor energy savings, reduce makeup air heating and cooling energy, increasing safety and reducing ambient kitchen noise levels.[27]
In variable climates, the system may include a reversing valve that switches from heating in winter to cooling in summer. By reversing the flow of refrigerant, the heat pump refrigeration cycle is changed from cooling to heating or vice versa. This allows a facility to be heated and cooled by a single piece of equipment by the same means, and with the same hardware.
Central, "all-air" air-conditioning systems (or package systems) with a combined outdoor condenser/evaporator unit are often installed in North American residences, offices, and public buildings, but are difficult to retrofit (install in a building that was not designed to receive it) because of the bulky air ducts required. (Minisplit ductless systems are used in these situations.) Outside of North America, packaged systems are only used in limited applications involving large indoor space such as stadiums, theatres or exhibition halls.
Demand controlled kitchen ventilation (DCKV) is a building controls approach of slowing down kitchen exhaust fans and subsequent supply air in response to the actual cooking loads in a commercial kitchen. Traditional commercial kitchen ventilation systems operate at 100% fan speed independent of the volume of cooking activity and DCKV technology changes that to provide significant fan energy and conditioned air savings. By deploying smart sensing technology, both the exhaust and supply fans can be controlled to capitalize on the Law of Affinity for motor energy savings, reduce makeup air heating and cooling energy, increasing safety and reducing ambient kitchen noise levels.[27]
For complex commercial heating and cooling systems, you need an expert. When you run into malfunctions, it’s not a DIY job to fix it. At Air Blue Heating and Cooling Inc., we know how important your HVAC systems are to running your commercial facility. Anytime you need repairs, maintenance, or installations, contact our team of licensed professionals. With our extensive industry background, we provide the highest quality service for your systems. We always adhere to strict standards for procedures, training, and customer service. As a Carrier Factory Authorized Dealer, we meet rigid standards for customer service and technical expertise, so you know you’re getting the very best. Give us a call any time of the day for efficient, accurate, and long-lasting commercial HVAC services in Elk Grove Village, Addison, Bedford Park, Bensenville, Elmhurst, Chicagoland and the surrounding suburbs.

Has your Dallas home air conditioning system stopped giving you the cool comfort you have come to expect? Or maybe you have decided it’s time to upgrade from a window unit to a whole home cooling solution. Whatever the case may be, you can rely on the expertise, experience, and know-how of the professionals at Baker Brothers Plumbing & Air Conditioning to complete your installation fast and correctly.


"I was experiencing problems with one of my rooms not getting enough air flow, I was reached out to and they got a better feel for what my situation was and gave me the best honest opinion about what I should do, I really appreciate their professionalism in the manner and not just trying to gain my business. They really looked out for me as a customer, and I couldn’t be more grateful!"
As a Carrier and GeoComfort dealer, with a wide variety of products to choose from, we can keep your family healthy and feeling comfortable all year long. We carry a complete line of energy efficient equipment with innovations that raise the standards of comfort and reliability, including air conditioners, heat pumps, gas furnaces, geothermal systems, programmable thermostats, humidifiers, air cleaners, ventilators and zoning products. Let the experts at Derousseau Heating & Cooling, Inc. help customize a solution that's right for you.
×